Artillery Genius Auto Bed Leveling

Auto bed leveling help needed.

Artillery genius auto bed leveling.

The machine now reserves bed leveling connectors allowing the user to easily upgrade the printer. The sensor will go in the first three pins labeled bgr. However artillery left some room for diy improvements. Probe the bed in a grid and apply mesh based compensation.

Best for an irregular bed. Artillery genius bed level test by schdriezie is licensed under the creative commons attribution license. For the artillery genius auto bed leveling mod to work reliably no movements should be present. After you manage to properly level the bed and have a good first layer you can add an extra m5 nut in the bottom of each corner.

Auto bed leveling help needed. In case you get fed up with turning bolts automatic bed leveling is possible image. It s important to have a good connection and the pins to sit snugly in the connector. I tried configuring my own marlin but no success my bl touch retracts as soon as it tries to home z and i can t test if it is the firmware s fault or my bl touch is faulty.

You can even use a nylon m5 nut to make sure they don t loosen themselves during printing. I tried configuring my own marlin but no success my bl touch retracts as soon as it tries to home z and i can t test if it is the firmware s fault or my bl touch is faulty. This was the bed leveling mod i did to my artillery genius. Artillery in its vanilla state the artillery genius only features manual bed leveling.

Probe the bed at 3 arbitrary points and apply a matrix to the bed s overall tilt. Probe the bed in a grid and like three point apply a matrix to the bed s overall tilt. Types of automatic bed leveling.